Asset protection, tamper, fire extinguisher tamper protection
Access Control and Intrusion _ Innovative. Reliable. Dynamic.

Tamperalert™ Fire Extinguisher Tamper Alarm

Tamperalert™ Fire Extinguisher Tamper Alarm is specially designed to protect the fire extinguisher/hose from being tampered with or misused. It can also be used to protect other important or valuable assets.

The system consists of a transmitter and receiver. The transmitter has a specially made steel loop which can be easily tired to the fire extinguisher or hose reel. When the fire extinguisher/hose is moved or tampered with, both the transmitter and receiver will sound an alarm, and at the same time, the alarm signal will be sent to the fire or alarm panel via the receiver. If needed, a repeater can be added to extend the RF range. 

Tamperalert™ Fire Extinguisher Tamper Alarm WSE25

WSE25 NEW
  • Immediately set alarm and report to fire/alarm panel when the extinguisher is moved – ensure the extinguisher is in normal position and good condition ready for emergency use all time
  • Low breaking strength design – it won’t interfere with fire fighting in any way
  • Dual loop model (two extinguishers share one transmitter) available – save cost
  • The antenna is situated inside of the plastic case – cannot be tampered
  • It has front cover tamper
  • Transmitter case and loop glug has IP rating 67 – suitable for outdoor use
  • Long RF range: 150m minimum (open space)
  • Large capacity: up to 1000 transmitter (fire extinguishers)
  • Fully supervision on the transmitter – tamper, low battery and loss of communication
  • Easy to use and program
  • It can also be used to protect other important or valuable assets

Transmitter WES25T

  • Will report current status every 1-2 hours to the receiver
  • Plug breaking strength: < 6 lbs
  • Battery: 1/2AA lithium; up to 3 years
  • Standard length of loop: 500mm; other sizes are available on request
  • Option of signal or dual loop model
  • IP67
  • Current: 10mA; 5uA standby
  • Wireless range: 150m (open air)
  • Frequency: 433.92MHz

Receiver – WSE25R

  • Voltage: 10-30VDC
  • Current: 300mA; 15mA standby
  • The unit reports Alarm, Tamper, Low Battery and RF comm. failure when they occur. 
  • 4-digit LED display
  • 4-relay outputs: to report alarm and supervision
  • Capacity: 1000